Home / AGCO / Allis 5650

AGCO Allis 5650 Specs ( 1994-1999 )

Compare Tractor

Production

Description Built in Italy / Original price was $22,000 in 1999
Distributor AGCO Allis
Manufacturer SAME

Engine

Engine type SLH 3.0L 3-cyl diesel
Fuel tank 15 gal (56.8 L)
Bore/Stroke 4.13x4.55 inches (105 x 116 mm)
Compression 17:1
Description SLH 1000.3 / diesel / 3-cylinder / air-cooled inline
Displacement 183 ci (3.0 L)
Pre-heating thermostart
Rated RPM 2350
Starter volts 12
Drawbar (claimed) 43.8 hp (32.7 kW)
Drawbar (tested) 43.8 hp (32.7 kW)
PTO (claimed) 47.8 hp (35.6 kW)
PTO (tested) 46.9 hp (35.0 kW)

Transmission

Description Four gears (1-4) in three ranges (low, medium, high) with synchronized shuttle. Gear shifts are synchronized.
Gears 12 forward and reverse / 16 forward and 8 reverse
Type sync shuttle
Transmission type 12-speed sync shuttle / 16-speed
Transmission type 12-speed sync shuttle / 16-speed

Mechanical

Description Power steering / Hydraulic wet disc brakes / Two-post ROPS.
Drive type Two- or four-wheel drive

Hydraulics

Pump flow 11.9 gpm (45.0 lpm)
Type open center
Valves 2

Hitch

Rear lift (at 24"/610mm) 4163 lbs (1888 kg)
Rear Type II

PTO

Engine RPM 540@2079
Rear PTO independent
Rear PTO Type 540 (1.375)

Electrical

Battery volts 12
Ground negative

Dimensions & Tires

Ag front 6.50-16
Ag rear 13.6R28
2WD Front tread 48.4 to 60.2 inches (122 to 152 cm)
2WD Wheelbase 77.8 inches (197 cm)
4WD Front tread 52.7 to 68.5 inches (133 to 173 cm)
4WD Wheelbase 75.8 inches (192 cm)
Height 87.9 inches (223 cm)
Length 133 inches (337 cm)
Rear tread 51.2 to 66.9 inches (130 to 169 cm)
Weight 4500 lbs (2041 kg)
Width 66.7 inches (169 cm)
2WD Wheelbase 77.8 inches (197 cm)
4WD Wheelbase 75.8 inches (192 cm)
Front tire 6.50-16
Rear tire 13.6R28
Weight 4500 lbs (2041 kg)

5650 Serial Numbers

1994 1000
1995 1001
1996 1111
Description FAQ: How to read a serial number table.
Location: Console, right side

OCED Tractor Test 1497

Description Diesel 12-speed 4WDJuly 1993 - September 1993, Link: OCED Tractor Test 1497 file / PTO performance / Drawbar performance / Gear 4N used for power test. / Gear 3N used for pull test.
Fuel use 2.8 gal/hour (10.6 l/hour) / 2.7 gal/hour (10.2 l/hour) / 3.5 gal/hour (13.2 l/hour)
Max power 43.8 hp (32.7 kW)
Max pull 4385 lbs (1989 kg)
Power at rated engine speed 46.9 hp (35.0 kW)
Power at rated PTO speed 46.7 hp (34.8 kW)

References

Description 5600 Series published in 1990, by AGCO

Speeds

Description With 13.6R28 rear tires. Reverse speeds are 8% slower than forward speeds.

Variants

Argon 50 similar SAME model