Home / AGCO / Allis 5660

AGCO Allis 5660 Specs ( 1994-1999 )

Compare Tractor

Production

Description Built in Italy / Original price was $26,000 in 1999
Distributor AGCO Allis
Manufacturer SAME

Engine

Engine type SLH 3.0L 3-cyl diesel
Fuel tank 15 gal (56.8 L)
Bore/Stroke 4.13x4.55 inches (105 x 116 mm)
Compression 17:1
Description SLH 1000.3 / diesel / 3-cylinder / air-cooled inline
Displacement 183 ci (3.0 L)
Pre-heating thermostart
Rated RPM 2350
Starter volts 12
Drawbar (claimed) 48.8 hp (36.4 kW)
Drawbar (tested) 48.8 hp (36.4 kW)
PTO (claimed) 56.9 hp (42.4 kW)
PTO (tested) 57 hp (42.5 kW)

Transmission

Description Four gears (1-4) in three ranges (low, medium, high) with synchronized shuttle. Gear shifts are synchronized.
Gears 12 forward and reverse / 16 forward and 8 reverse
Type sync shuttle
Transmission type 12-speed sync shuttle / 16-speed
Transmission type 12-speed sync shuttle / 16-speed

Mechanical

Description Power steering / Hydraulic wet disc brakes / Two-post ROPS.
Drive type Two- or four-wheel drive

Hydraulics

Pump flow 11.9 gpm (45.0 lpm)
Type open center
Valves 2

Hitch

Rear lift (at 24"/610mm) 4530 lbs (2054 kg)
Rear Type II

PTO

Engine RPM 540@2079
Rear PTO independent
Rear PTO Type 540 (1.375)

Electrical

Battery volts 12
Ground negative

Dimensions & Tires

Ag front 7.50-16
Ag rear 14.9R28
2WD Front tread 48.4 to 60.2 inches (122 to 152 cm)
2WD Wheelbase 82.9 inches (210 cm)
4WD Front tread 52.7 to 68.5 inches (133 to 173 cm)
4WD Wheelbase 80.9 inches (205 cm)
Height 88.5 inches (224 cm)
Length 141.3 inches (358 cm)
Rear tread 55.1 to 70.9 inches (139 to 180 cm)
Weight 6020 lbs (2730 kg)
Width 72.6 inches (184 cm)
2WD Wheelbase 82.9 inches (210 cm)
4WD Wheelbase 80.9 inches (205 cm)
Front tire 7.50-16
Rear tire 14.9R28
Weight 6020 lbs (2730 kg)

5660 Serial Numbers

1994 1000
1995 1001
1996 1087
Description FAQ: How to read a serial number table.
Location: Console, right side

OCED Tractor Test 1501

Description Diesel 12-speed 4WDJuly 1993 - 1993, Link: OCED Tractor Test 1501 file / PTO performance / Drawbar performance / Gear 1F used for power test. / Gear 3N used for pull test.
Fuel use 3.3 gal/hour (12.5 l/hour) / 3.2 gal/hour (12.1 l/hour) / 3.3 gal/hour (12.5 l/hour)
Max power 48.8 hp (36.4 kW)
Max pull 4795 lbs (2175 kg)
Power at rated engine speed 57 hp (42.5 kW)
Power at rated PTO speed 56.3 hp (42.0 kW)

References

Description 5600 Series published in 1990, by AGCO

Variants

Argon 60 similar SAME model